-->

5 Steps Wifi Hacking – Cracking WPA2 Password using Kali Linux


5 Steps Wifi Hacking – Cracking WPA2 Password


5 Steps Wifi Hacking – Cracking WPA2 Password

 

Requirements :-

1. Wireless Card ( Wifi Adapter) In this tutorial I use Tenda Wifi adapter

 2. Kali Linux Os or any linux os (Use Virtual Box or Vmware)

5 Steps Wifi Hacking – Cracking WPA2 Password:

 

Step 1 :- Open your terminal (CTRL+ALT+T) and type airmon-ng

 

 

 this command will lists our wireless card that attached with our system.

 

 

Step 2 :- The next step we need to stop our wireless monitor mode by running airmon-ng stop wlan1 

 

  

(Monitor Mode Disabled)  

 

 

Step 3 :- Now we ready to capture the wireless traffic around us. By running airodump-ng wlan1 our wireless interface will start capturing the data.

 

 

From the above picture, we can see many available access point with all the information. Make Victims anyone Except yours.(Otherwise 1st try with your network) 

 

Information:

BSSID (Basic Service Set Identification): the MAC address of access point

PWR: Signal level reported by the card.

Beacons: Number of announcements packets sent by the AP

#Data: Number of captured data packets (if WEP, unique IV count), including data broadcast packets.

#/s: Number of data packets per second measure over the last 10 seconds.

CH: Channel number (taken from beacon packets).

MB: Maximum speed supported by the AP. If MB = 11, it's 802.11b, if MB = 22 it's 802.11b+ and higher rates are 802.11g.

ENC: Encryption algorithm in use.

CIPHER: The cipher detected. TKIP is typically used with WPA and CCMP is typically used with WPA2.

AUTH: The authentication protocol used.

ESSID: Shows the wireless network name. The so-called “SSID”, which can be empty if SSID hiding is activated.

 

 

Step 4 :- From the step 3 above, we can find access point with encryption algorithm WPA2 and note the AP channel number. Now we will find out whether target AP has WPS enabled or not. 

type wash -i wlan0 -c 8 -C -s (-c[channel no. mine is 8] and type everything as it is)

 

 if the WPS Locked status is No, then we ready to crack and move to step 5.

 

 

Step 5 :- The last step is cracking the WPA2 password using reaver.

reaver -i <your_interface> -b <wi-fi victim MAC address> –fail-wait=360

Because we already get the information from step 3 above, so my command look like this:

reaver -i wlan0 -b E0:05:C5:5A:26:94 –fail-wait=360

 

 

Tadaa ! 

 

It took about 5 hours to crack 19 characters WPA2 password (vishnuvalentino.com) from my Kali virtualBox, but it depend with our hardware and wireless card.




KumarJeeru

Also Read

Post a Comment